作者：王素英1, 王瑾2, 李超峰3
作者单位：1. 郑州经贸学院土木建筑学院，河南 郑州 451191;
2. 上海理工大学环境与建筑学院，上海 200093;
3. 河南鼎力晟环保科技有限公司，河南 郑州 450047
关键词：换热器;热冷混合;泵控;性能测试;参数评价
摘要：
以热冷混合波纹板式换热器为研究对象，搭建实验测试平台，提出用总压降、换热效能、传热量与消耗泵功比值和流量分布不均匀系数四个性能指标，评价实验测试的板式换热器性能。研究结果表明：板式换热器都发生总压降随质量流量提高而增大。随着波纹倾角的增大，总压降也随之提高。当质量流量保持恒定时，大波纹倾角换热器达到最大效能状态，小波纹倾角时换热效能最低。当波纹倾角增大后，获得更高的换热效能。60°换热器表现出最高的温差利用效率。提高质量流量，板式换热器Q/N比值发生减小，形成更平缓曲线。混合型换热器获得比其他单一纹倾角更高的Q/N比值。随着波纹倾角的增大，不均匀系数速率也更快。对同一板式换热器进行测试发现，当质量流量增加时，不均匀系数也持续提高。
Performance test and main parameter evaluation of pump controlled heat and cold mixed corrugated plate heat exchanger
WANG Suying1, WANG Jin2, LI Chaofeng3
1. School of Civil Engineering and Architecture, Zhengzhou University of Economics and Trade, Zhengzhou 451191, China;
2. School of Environment and Architecture, University of Shanghai for Science and Technology, Shanghai 200093, China;
3. Henan Dingli Sheng Environmental Protection Technology Co., Ltd., Zhengzhou 450047, China
Abstract: Taking the heat and cold mixed corrugated plate heat exchanger as the research object, an experimental test platform was built, and four performance indexes were proposed to evaluate the performance of the experimentally tested plate heat exchanger, including the total pressure drop, the heat transfer efficiency, the heat transfer and pump work consumption ratio and the non-uniform coefficient of flow distribution. The results show that the total pressure drop of plate heat exchanger increases with the increase of mass flow rate. With the increase of the corrugation angle, the total pressure drop also increases. When the mass flow rate remains constant, the heat exchanger with large corrugated angle reaches the maximum efficiency, and the heat exchanger with small corrugated angle reaches the lowest efficiency. When the corrugation angle increases, higher heat transfer efficiency is obtained. The 60° heat exchanger shows the highest utilization efficiency of temperature difference. With the increase of mass flow rate, the Q/N ratio of plate heat exchanger decreases and a more gentle curve is formed. The Q/N ratio of the mixed heat exchanger is higher than that of other single grain angles. With the increase of the corrugation angle, the rate of non-uniformity coefficient is also faster. It is found that when the mass flow rate increases, the non-uniformity coefficient continues to increase.
Keywords: heat exchanger;hot and cold mixed;pump control;performance test;parameter evaluation
2022, 48(4):154-158 收稿日期: 2021-04-02;收到修改稿日期: 2021-05-08
基金项目: 河南省高等学校重点科研项目（20A480006）；河南省科技发展计划项目（202102310556）
作者简介: 王素英（1986-），女，河南郑州市人，讲师，硕士，主要从事暖通系统设计
参考文献
[1] SHOKOUHMAND H, HASANPOUR M. Effect of flow maldistribution on the optimal design of plate heat exchanger using constrained multi objective genetic algorithm[J]. Case Studies in Thermal Engineering, 2020, 18: 100570
[2] 严晓生, 吴迪. CCHP系统优化配置及与传统热电联产系统的性能对比分析[J]. 中国测试, 2020, 46(7): 159-168
[3] 罗林聪, 邢鑫, 朱君, 等. 工业在用换热器一体化能效检测设备及技术研究[J]. 中国测试, 2020, 46(4): 81-85
[4] JAMIL M A, DIN Z U, GORAYA S T, et al. Thermal-hydraulic characteristics of gasketed plate heat exchangers as a preheater for thermal desalination systems[J]. Energy Conversion and Management, 2020, 205: 1123-1136
[5] 陈家浩, 邓斌. 基于Fluent的压裂车液压油散的翅片散热优化[J]. 液压与气动, 2019(6): 101-105
[6] 曹凡, 李迪, 李耀民, 等. 基于Isight平台的房车空调送风参数优化[J]. 液压与气动, 2019(4): 34-41
[7] ZHANG J, ZHU X, MONDEJAR M E, et al. A review of heat transfer enhancement techniques in plate heat exchangers[J]. Renewable and Sustainable Energy Reviews, 2019, 101: 305-328
[8] ZAHRANI S A, IALAM M S, XU F, et al. Thermal performance investigation in a novel corrugated plate heat exchanger[J]. International Journal of Heat and Mass Transfer, 2020, 148: 119095
[9] 张营, 张伟江, 李晓光. 耦合太阳能辅热的AA-CAES系统储热特性分析及优化[J]. 中国测试, 2019, 45(11): 155-160
[10] JIN S, HRNJAK P. Effect of end plates on heat transfer of plate heat exchanger[J]. International Journal of Heat and Mass Transfer, 2017, 108: 740-748
[11] GRABENSTEIN V, POLZIN A E, KABELAC S. Experimental investigation of the flow pattern, pressure drop and void fraction of two-phase flow in the corrugated gap of a plate heat exchanger[J]. International Journal of Multiphase Flow, 2017, 91: 155-169
[12] KWON O J, SHON B, KANG Y T. Experimental investigation on condensation heat transfer and pressure drop of a low GWP refrigerant R-1233zd(E) in a plate heat exchanger[J]. International Journal of Heat and Mass Transfer, 2019, 131: 1009-1021
[13] ATTALLA M, MAGHRABIE H M. Investigation of effectiveness and pumping power of plate heat exchanger with rough surface[J]. Chemical Engineering Science, 2020, 211: 115277
[14] JAMILl M A, UD D Z, GORAYA T S, et al. Thermal-hydraulic characteristics of gasketed plate heat exchangers as a preheater for thermal desalination systems[J]. Energy Conversion and Management, 2020, 205: 112425
[15] GUREL B, AKKAYA V R, GOLTAS M, et al. Investigation on flow and heat transfer of compact brazed plate heat exchanger with lung pattern[J]. Applied Thermal Engineering, 2020, 175: 115309
